Smart module of relay outputs controlled via LAN

Lantick PE-8-0 has 8 relay outputs. Outputs status is available via LAN / WAN with supported protocols (shown below). The device has built-in website. The main tab shows status of outputs, assigned name and indicator allowing to output control.

Additionally, there is a visualization tab. The user can design his own graphics. Icons of inputs and outputs can be moved around the whole graphics. The selected output can be activated by clicking on the appropriate icon.

The Lantick series can transmit input status and react autonomously. M2M communication is available.

Preview

« 1 of 2 »

Highlights

Technical data

Conffiguration waybuilt-in web server
Number of outputs8
Type of outputsrelay NO
Supply voltage10-24VDC
InterfaceRJ45 (10BASE-T)
Supported protocolsHTTP, TCP, SNMP, modbus TCP,
Working temperature5 – 50 °C
Storage temperature-10 to 85 °C
Humidity5-95%

Supported protocols

The inputs status and outputs control are available through:

  • internet browser,
  • Linux OS command line,
  • Modbus TCP protocol,
  • SNMP protocol,
  • HTTP (GET) protocol,
  • KNX-IP protocol,
  • smartphone/tablet with Android.

M2M connection

Inveo devices are designed in such way that they can work with each other. For example, Nano Temp can send alarm state to Lantick, activating output 2 (e.g. fan). Devices with digital inputs or alarm states can send data, while devices with outputs can respond to received data.

Lantick 8-0 can receive M2M signal.

M2M feature support protocol

  • KNX,
  • TCP protocol,
  • UDP protocol,
  • HTTP GET.

Device configuration

At the first start-up, it is necessary to configure the device. The easiest way to configure Inveo devices is to use a Discoverer application. The program is available here. After installing and launching the application, all Inveo devices connected to the network will appear in the table. If the device has not been found, select another Interface or check the connection to the router.

If the devices have the Enable Remote Config service disabled, it is necessary to change the settings manually by changing the computer’s IP address. The precise device configuration instruction can be found in the manual.

Buy here

Our website uses cookies in accordance with the EU Privacy Policy.

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close