Waterproof RFID reader in hermetic IP65 housing

« 1 of 2 »

RFID IND LED is an industrial, waterproof RFID reader, available in several standards, designed to work in demanding conditions. The module has a hermetic housing IP65. The device has two digital inputs and two relay outputs. Communication takes place via the Ethernet and RS485 port. Individual standards are supported depending on the device version.

TransponderDevice
Mifare Classic, Mifare Plus (UID), Mifare DESFire (UID)RFID IND LED Mif
Unique EM4100 EM4102 RFID IND LED Uni
HID iClass (tylko CSN)RFID IND LED iCla
HID 125kHz RFID IND LED H125
ICODE (ISO 15693)RFID IND LED Ico
HITAG (HITAG 2)RFID IND LED HT2

General features of the RFID reader

Communication

Advanced software gives the ability to communicate via:

  • Modbus RTU,
  • Modbus TCP,
  • HTTP Client/Server,
  • ICMP,
  • SNMP,
  • embedded web server.

Additional information

The reader can store 1000 transponders (optional 4000) and 30,000 logs in the device’s memory. Using the protocols, the user has several ways to download and read saved logs. Additionally, by assigning a tag to a appropriate person, the administrator can authorize the tag even depending on the time of day. The device has two digital inputs and two relay outputs, which allows to restrict access to the room or machine.

Technical data

Power supply

  • DC: 10 V – 24V and optional
  • Passive PoE or
  • PoE IEEE 802.3af,
  • Power consumption: max 2.5W ( ~200mA@12V).

Transponder and memory

  • Tag reading distance: up to 8cm from the front of the device (LED side),
  • Memory of the ID numbers: 1 000,
  • Memory of the events: 30 000,
  • Defining access hours for 4 groups of ID numbers,
  • Assign names to ID numbers.

Input

  • Number of the inputs: 2,
  • Type of the inputs: dry contact NO.

Output

  • Number of the outputs: 2,
  • Type of the outputs: relay NO,
  • Maximum load: 1A @ 30VDC.

Device configuration

At the first start-up, it is necessary to configure the device. The easiest way to configure Inveo devices is to use a Discoverer application. The program is available here. After installing and launching the application, all Inveo devices connected to the network will appear in the table. If the device has not been found, select another Interface or check the connection to the router.

If the devices have the Enable Remote Config service disabled, it is necessary to change the settings manually by changing the computer’s IP address. The precise device configuration instruction can be found in the manual.

Our website uses cookies in accordance with the EU Privacy Policy.

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close